EPG Multi STACK Water Fuel Cell


The flow rate of the slurry was about 50 ips in the ferrofluid
systems (single tier systems) ref: tech
The circumference of the mechanical EPG series (single tier systems) was about 50 inches ref rwg replication
Tthe flashing timing led rate was about 60 times/minute in the single tier system ref :Dealership tape
By adjusting the flow rate and rate of magnetization in the alignment coils ,the magnetized portions of the ferrofluid and/or
mag-gas are synchronized to the position of the pickup coils. This reduces the back eddy current and Lorenz forces while
the slurry or gas are circulated The maggas systems were likely tuned in a similar manner although the 90 ips reported '
for multi-tier is due to higher speed required to compensate for the lower magnetic flux per cubic inch
but this is compensated by a greater number of windings in the multi-tier systems

_j.jpg)



NOTE also See Gas Battery Here



NOTE also See Gas Stacked Resonant Cavity Here








In these Version We attempt to Stack the Cells We have not put the inter tubing or balance drain tube on yet in these postures more pictures will come also more advanced versions . It is Expected that you know that Stan was also using ultrasonic vibration this can be replicated with a ultra sonic fogger and you can change out led for correct 640 nm red wave length together we can change the world do share back to dan so we can forward teach as you build
Note Fogger will go in the center of each cell array the cells will need wind cut like gas processor to allow light in will work with out cur in cell also
GOD SPEED





